THIẾT BỊ CĂN CHỈNH LỰC CĂNG DÂY MITSUBOSHI BELT PENCIL

Sản Phẩm

THIẾT BỊ CĂN CHỈNH LỰC CĂNG DÂY MITSUBOSHI BELT PENCIL
Giá : Liên hệ
MASP : MITSUBOSHI pencil v-belt, Pencil type belt tension gauge
Nhà sản xuất : GATE UNITTA JAPAN
Thiết bị đo và kiểm tra lực căng dây curoa V-Belt pencil type được sử dụng để đánh giá và căn chỉnh lực căng dây phù hợp theo tiêu chuẩn của nhà sản xuất. Ứng với mỗi loại dây belt khác nhau dây mới-dây đã sử dụng-tốc độ vòng quay sẽ có độ căng khác nhau. Việc căn chỉnh thường được thực hiện định kỳ từ 24-48 giờ sau khi dây hoạt động. Việc căn chỉnh rất quan trọng nhằm đánh giá được chất lượng dây belt, độ căng và độ bền dây, giúp việc hoạt động của dây chuyền ổn định.

Chi tiết Sản phẩm

MITSUBOSHI Japan

Pencil type

belt tension gauge

V-Belt Tension Gauge

Proper tension is the key to long, efficient, trouble-free belt operation. When you install a new set of belts, use the gauge to establish correct tension.

Then, to maintain performance, re-check belt tension after 24-48 hours. The payoff is maximum belt life, reduced downtime and uninterrupted equipment service.

Belt Tension testers are for checking tensions on your synchronous belt drives and V-Belt.

How To Check V-Belt Tension

Proper drive belt tension is a critical setting on your factory. A loose drive belt can cause problems like wavy cuts or diving blades. An overtightened drive belt can cause premature wear and failure on many parts of the sawmill including cylindrical drive bearing, drive belt, and even engine failure.

The drive belt used on your factory is a V belt design. The V belt transfers power from the drive pulley to the driven pulley. A properly tensioned belt will sit in the V groove of the pulley so that the sides of the belt are the only surfaces touching. This position allows the belt to grip the pulley and still have some slippage if the drive gets in a bind.

The only way to properly set the drive belt tension is to use a belt tension gauge (MITSUBOSHI V-Belt tension gauge pencil type ). Belt tension is set by the amount of pounds (force) it takes to move the tightened belt a set amount of inches. To find this setting for your sawmill, refer to the Drive Belt Tension Measurement Guide on this page or review in your sawmill manual.

Manual Belt Tension Tester

The spring scale type tester measures how much force is required to deflect the belt a specified distance at the center of its span. This is the force deflection method of tensioning belts. The Sonic Tension Meter measures the vibration of the belt span and instantly converts the vibration frequency into belt static tension. This is the span vibration method of tensioning belts.

Video: How To Measure Belt Deflection | Pencil type belt tension gauge

Specification

* Load Range: 15kg

* Material: Steel plate

* Length: 200mm

* Measurement Range: 60mm

Pic.: MITSUBOSHI V-Belt tension gauge ( 15Kgf/150N) at Semiki's warehouse

Maintenance and calibration :

► We also have calibration certificate attached ( optional )
► Please re-calibrate after use for a certain period through our purchase store. Local Vietnam : SEMIKI CORP